Injector and Valve Adjustment Engine Assembly (00-02) N14 Page 0-108 Select a feeler gauge for the correct valve lash specification. Valve Lash Specifications Intake Exhaust 0.35 mm 0.68 mm [0.014-inch] [0.027-inch] Insert the feeler gauge between the top of the crosshead and the rocker lever pad. Two different methods for establishing valve lash clear- ance are described below. Either method can be used; however, the torque wrench method has proven to be the most consistent. Torque Wrench Method: Use the inch pound torque wrench, part No. 3376592, (normally used to set preload on STC injectors), and tighten the adjusting screw. Torque Value: 0.6 to 0.7 [5 to 6 in-lb] Feel Method:
Tighten the adjusting screw until a slight drag is felt on the feeler gauge. Hold the adjusting screw in this position. The adjusting screw must not turn when the lock nut is tightened. Torque Values: With torque wrench adapter, 54 [40 ft-lb] Part No. ST-669 Without adapter 68 [50 ft-lb] After tightening the lock nut to the correct torque value, check to make sure the feeler gauge will slide backward and forward between the crosshead and the rocker lever with only a slight drag.