Cummins — STC ENGINES

Engine Assembly (00-02) Injector and Valve Adjustment N14 Page 0-109 If using the feel method, attempt to insert a feeler gauge that is 0.03 mm [0.001-inch] thicker between the cross- head and the rocker lever pad. The valve lash is not correct when a thicker feeler gauge will fit. After adjusting the injector on cylinder No. 1 and the valves on cylinder No. 1, rotate the accessory drive; and align the next valve set mark with the pointer. Adjust the appropriate injector and valves following the Injector and Valve Adjustment Sequence Chart.

CELECT™Engine Injector and Valve Adjustment Sequence Bar Engine in Direction Pulley Set Cylinder of Rotation Position Injector Valve Start A 1 1 Advance to B 5 5 Advance to C 3 3 Advance to A 6 6 Advance to B 2 2 Advance to C 4 4 Firing Order: 1-5-3-6-2-4 Repeat the process to adjust all injectors and valves correctly. Install the engine brakes again, if equipped. Refer to Engine Brake - Installation in this Section. STC Engines The valve set marks are located on the accessory drive pulley. The marks align with a pointer on the gear cover. Use the accessory drive shaft to rotate the crankshaft. The crankshaft rotation is clockwise when viewed from the front of the engine.

The cylinders are numbered from the front end of the engine. The engine firing order is 1-5-3-6-2-4.