Cummins — STC ENGINES

Injector and Valve Adjustment Engine Assembly (00-02) N14 Page 0-110 All overhead (valve and injector) adjustments must be made when the engine is cold (any stabilized coolant temperature at 60°C [140°F] or below). Each cylinder has three rocker levers: The exhaust rocker lever (1). The injector rocker lever (2). The intake rocker lever (3). The two levers closest to the center of each rocker hous- ing are the intake rocker levers. The two levers closest to the ends of the rocker housing are the exhaust rocker levers. The valves and the injectors on the same cylinder are not adjusted at the same index mark on the accessory drive pulley.

STC Engine Injector and Valve Adjustment Sequence Bar Engine in Direction Pulley Set Cylinder of Rotation Position Injector Valve Start A 3 5 Advance to B 6 3 Advance to C 2 6 Advance to A 4 2 Advance to B 1 4 Advance to C 5 1 Firing Order: 1-5-3-6-2-4 One pair of valves and one injector are adjusted at each pulley index mark before rotating the accessory drive to the next index mark. Two crankshaft revolutions are required to adjust all the valves and the injectors. Rotate the accessory drive in the direction of engine rotation. The accessory drive will rotate clockwise , on a right hand engine, when looking at the front of the engine.

Align the ‘‘A’’ mark on the accessory drive pulley with the pointer on the gear cover.