Cummins — STC ENGINES

Injector and Valve Adjustment Engine Assembly (00-02) N14 Page 0-114 After tightening the lock nut to the correct torque value, check to make sure the feeler gauge will slide backward and forward between the crossheads and the rocker lever with only a slight drag. If using the feel method, attempt to insert a feeler gauge that is 0.03 mm [0.001-inch] thicker between the cross- head and the rocker lever pad. The valve lash is not correct when a thicker feeler gauge will fit. After adjusting the injector on cylinder No. 3 and the valves on cylinder No. 5, rotate the accessory drive; and align the next valve set mark with the pointer.

Adjust the appropriate injector and valves following the Injector and Valve Adjustment Sequence Chart. STC Engine Injector and Valve Adjustment Sequence Bar Engine in Direction Pulley Set Cylinder of Rotation Position Injector Valve Start A 3 5 Advance to B 6 3 Advance to C 2 6 Advance to A 4 2 Advance to B 1 4 Advance to C 5 1 Firing Order: 1-5-3-6-2-4 Repeat the process to adjust all injectors and valves correctly. Install the C-Brakes again, if equipped. Refer to the N14 Troubleshooting and Repair Manual, Bulletin No. 3810456.