Engine Assembly (00-02) Engine Brake - Installation N14 Page 0-115 Engine Brake - Installation Install two guide pins into each rocker lever housing. Install new C-Brake housing gaskets and the C-Brakes. Remove the guide pins. Install the C-Brake capscrews. Tighten the capscrews in the sequence shown to the torque value listed below. Torque Value: 102 [75 ft-lb] Engine Brake - Adjustment C-Brake Caution: To get maximum brake operating efficiency and to prevent engine damage, it is important to follow the instructions on the following pages. If the engine is equipped with a C-Brake, use the following adjustment procedure. NOTE:
C-Brake adjustment specifications are found on the C-Brake dataplate located on the exhaust side of the C- Brake housing. Slave piston adjustment must be made with the engine stopped and cold (stabilized water temperature or 60°C [140°F] or below). The exhaust valves on the cylinder which are to be adjusted must be in the closed position.