Engine Brake - Adjustment Engine Assembly (00-02) N14 Page 0-116 Rotate the crankshaft in the direction of engine rotation. Align the ‘‘A’’ mark on the accessory drive pulley with the pointer on the gear cover. When the mark is aligned, the intake and exhaust valves rocker levers must be loose for cylinder No. 5. NOTE: Both the intake and exhaust valves are closed when both rocker levers are loose and can be moved from side to side. If both valves are not closed, rotate the accessory drive one complete revolution; and align the mark with the pointer again. The instructions using the ‘‘A’’ mark to begin the adjust- ments are for illustration purposes.
Adjustments can start at any of the cylinders as shown. C-Brake Set Position - STC and CELECT™ Bar In Direction Pulley Position Set Brake Start A 5 Advance to B 3 Advance to C 6 Advance to A 2 Advance to B 4 Advance to C 1 Firing Order: 1-5-3-6-2-4 Right Hand Rotation Caution: Use of the wrong adjusting screw can result in severe engine damage. See the latest N14 parts publi- cation information.