Cummins — C-BRAKE

Engine Assembly (00-02) Engine Brake - Adjustment N14 Page 0-117 Loosen the lock nut for the No. 5 slave piston adjusting screw. Install a dial indicator, Part No. 3375006, over the No. 5 slave piston adjusting screw. Use the adapter, Part No. 3823826, to mount the dial indicator fixture to the C-Brake. Tighten the adjusting screw until the slave piston con- tacts the crosshead. Zero the gauge with the dial indicator stem resting on the adjusting screw. Loosen the adjusting screw until the indicator needle shows 0.58 mm [0.023-inch]. NOTE: C-Brake adjustment specifications are found on the C-Brake dataplate located on the exhaust side of the C- Brake housing.