Cummins — INTAKE MANIFOLD - INSTALLATION

Intake Manifold - Installation Engine Assembly (00-02) N14 Page 0-120 Install the covers on the rocker lever housing. Install the ten capscrews and washers in each cover. Tighten the capscrews in each cover in the sequence shown. Torque Value: 12 [105 in-lb] Install the rubber grommet, breather tube, and oil filler cap into the rocker housing covers, if applicable. Intake Manifold - Installation Install the intake air connection to the intake manifold. Make sure the gasket is seating in its groove. Install and tighten the four capscrews. Torque Value: 34 [25 ft-lb] Using new gaskets, install the intake manifold onto the cylinder head mounting surfaces. Install and tighten the nine capscrews.

Torque Value: 47 [35 ft-lb]