Engine Assembly (00-02) CELECT™Intake Air Temperature Sensor - Installation N14 Page 0-121 CELECT™Intake Air Temperature Sensor - Installation Install the sensor in the engine. Tighten the sensor. Torque Value: 35 [25 ft-lb] Make sure the sensor is installed with a new o-ring. CELECT™Boost Pressure Sensor - Installation Install the sensor on the engine. Tighten the capscrews. Torque Value: 30 [22 ft-lb] Make sure the sensor has a sealing ring on the bottom side of the sensor. Viscosity Sensor - Installation On STC engines install the bracket to the viscosity sen- sor. Install the two bracket capscrews and tighten. Torque Value:
27 [20 ft-lb] Connect the flexible hoses to the viscosity sensor fittings. Torque Value: 1. 11 [95 in-lb] 2. 20 [15 ft-lb] 3. 27 [20 ft-lb] NOTE: Do not allow dirt or debris to enter the oil lines. Install the entire assembly with flex hoses attached to the cylinder block pan rail. Install the two capscrews and tighten. Torque Value: 68 [50 ft-lb]