Lubricating Oil Pump Signal Line - Installation Engine Assembly (00-02) N14 Page 0-122 Connect the sensor drain line (1) to the tee fitting on the cylinder block. Torque Value: 27 [20 ft-lb] Connect the pressure signal line (1) to the lubricating pump fitting (2) and the rifle pressure supply line (3) to the oil rifle fitting (4). Torque Values: 1. 10 [89 in-lb] 3. 10 [89 in-lb] Lubricating Oil Pump Signal Line - Installation On CELECT™engines, install the DFC signal line. Tighten the signal line tube nuts. Torque Value: 14 [120 in-lb] Lubricating Oil Transfer Tube - Installation Install a new rectangular sealing ring in the lubricating oil pump mounting flange.
Use clean vegetable oil to lubricate the seal. Install the sealing ring expander (1), Part No. 3376844, into the end of the lubricating oil transfer tube, and push the tube through the flange. Remove the sealing ring expander from the suction tube.