Engine Assembly (00-02) STC Oil Control Valve - Installation N14 Page 0-129 Connect the actuator harness to each of the pass through connectors along the side of the rocker lever housing. Make sure the connector clicks/snaps into place. Install a new plastic wire tie, Part No. 3062329, to each of the pass through connectors to hold the actuator harness to the pass through connectors. Connect the fuel shutoff control wire to the fuel shutoff solenoid. Tighten the retaining nut. Torque Value:
2.8 [25 in-lb] Connect the Deutsch three pin connector that contains the vehicle key switch, fan clutch, and engine brake con- trol wires to the three pin connector which is wired directly into the Deutsch nine pin connector on the sensor harness. STC Oil Control Valve - Installation Install the mounting plate. Tighten the two capscrews. Torque Value: 68 [50 ft-lb] Install the STC oil control valve to the mounting plate with the two capscrews. Tighten the capscrews. Torque Value: 41 [30 ft-lb]