Cummins — CELECT™ ACTUATOR HARNESS - INSTALLATION

CELECT™Actuator Harness - Installation Engine Assembly (00-02) N14 Page 0-128 On engines equipped with engine brakes, connect the engine brake harness to the sensor harness. Wire tie the harness to the fuel tubing at the rear of the engine. CELECT™Actuator Harness - Installa- tion Install the actuator harness on the engine. Install the actuator harness amp connector to the ECM. Tighten the two connector capscrews to the ECM. Torque Value: 2.0 [18 in-lb] Install the actuator harness retaining clamps to the sup- port bracket and to the rear of the No. 3 rocker housing. Tighten the capscrews. Torque Value: 20 [15 ft-lb]