Engine Assembly (00-02) CELECT™Sensor Harness - Installation N14 Page 0-127 CELECT™Sensor Harness - Installa- tion Install the sensor wiring harness on the engine. Install the sensor harness amp connector to the elec- tronic control module (ECM). Tighten the connector cap- screws to the ECM. Torque Value: 2.0 [18 in-lb] Install the sensor wiring harness retaining clamps to the support bracket and the engine block. Torque Value: 20 [15 ft-lb] Install the mounting hardware and connect the following sensors to the sensor harness. Oil pressure sensor Oil temperature sensor Ambient air pressure sensor Fuel shutoff control wire Engine position sensor Coolant temperature sensor