CELECT™Lubricating Oil Pressure Sensor - Installation Engine Assembly (00-02) N14 Page 0-126 Connect and tighten the inlet and outlet fuel hoses to the cooling plate. Inspect for paint or grease on the cooling plate. CELECT™Lubricating Oil Pressure Sensor - Installation Install the sensor on the engine. Tighten the capscrews. Torque Value: 30 [22 ft-lb] Install the oil pressure signal line. Push the connectors until they lock. CELECT™Ambient Air Pressure Sensor - Installation Install the sensor on the engine. Tighten the capscrews. Torque Value: 30 [22 ft-lb] Push the connectors together until they lock.
CELECT™Electronic Control Module (ECM) - Installation Install the ECM to the cooling plate. Tighten the six metric capscrews. Torque Value: 7.3 [65 in-lb] Make sure the star washer is installed under one of the capscrews. Caution: Do not paint the back side of the ECM. Make sure there is no grease or dirt between the ECM and the cooling plate.