Cummins — WATER PUMP - INSTALLATION

Engine Assembly (00-02) Water Pump - Installation N14 Page 0-133 Rotate the crankshaft 360 degrees, maintaining the po- sition of the crankshaft (either toward the front or the rear) in relation to the block. Record the total indicator motion. Replace the damper if wobble exceeds 0.18 mm [0.007- inch] per 25.4 mm [1.0 inch] of radius. This is the same as 0.09 mm [0.0035-inch] per 25.4 mm [1.0 inch] of damper diameter. Water Pump - Installation Caution: The water pump must have a dowel pin locat- ing hole (1) and oil cooler return passage (2). Engine damage will occur due to lack of coolant flow through the oil cooler if the passage is not present.

Install the water pump with a new gasket to the block using the six mounting capscrews. Tighten the capscrews to the following torque values: Tighten to 15 [10 ft-lb]. Tighten to 30 [20 ft-lb]. Tighten to 47 [35 ft-lb].