Water Pump Belt - Installation and Adjustment Engine Assembly (00-02) N14 Page 0-134 Water Pump Belt - Installation and Adjustment Visually inspect the pulley alignment. Pulley misalign- ment must not exceed 0.5 mm per cm [1/16-inch per foot] of distance between the pulley centers. Inspect and repair or replace the idler pulley or water pump if pulley misalignment exceeds 0.5 mm per cm [1/16-inch per foot]. Install a new belt on the pulleys. Turn the adjusting screw to adjust belt tension. NOTE: Belt tension can increase when the lock nut is tight- ened. Do not adjust belt tension to full value with the ad- justing screw. Use Part No.
ST-1293 (Borroughs) or 3822525 (Click- Type) Belt Tension Gauge to measure six-rib belt tension. New Belt Tension Used Belt Tension* 710 N [160 lb] 580 N [130 lb] * A belt is considered used if it has been in operation for 10 minutes or longer. Tighten the idler pulley shaft lock nut. Torque Value: 68 [50 ft-lb] Loosen the adjusting screw 1/2-turn to prevent breakage. Measure the belt tension again. Adjust if necessary.