Engine Assembly (00-02) Thermostat Housing - Installation N14 Page 0-135 Thermostat Housing - Installation Install the water transfer tube with new o-rings into the water pump housing. Apply a non-petroleum based lu- bricant such as soap or vegetable oil to the o-rings on each end of the tube and to the bores in the water pump housing and the thermostat housing cover. Install the thermostat housing assembly and mounting gasket on the rocker lever housing and onto the water transfer tube. Install the four mounting capscrews and washers. Tighten the capscrews. Torque Value: 47 [35 ft-lb] CELECT™Coolant Temperature Sensor - Installation Make sure the sensor has an o-ring.
Install the sensor in the engine. Tighten the sensor. Torque Value: 34 [25 ft-lb] Push the electrical connector into the sensor until it locks in place. Air Compressor Coolant Inlet and Outlet Tubes - Installation NOTE: If rubber grommets are used on the coolant lines, be sure they are installed carefully to prevent cuts or tears to the grommets which will cause coolant leaks. When flexible tubing is used, make sure that it does not rub any other surfaces.