Engine Assembly (00-02) Fan Belts - Installation and Adjustment N14 Page 0-137 Fan Belts - Installation and Adjustment Visually inspect the pulley alignment. Pulley misalign- ment must not exceed 0.5 mm per cm [1/16-inch per foot] of distance between the pulley centers. Inspect, repair, or replace the fan hub or the fan hub support bracket if pulley misalignment exceeds 0.5 mm per cm [1/16-inch per foot]. Install new belts on the pulley. When a drive pulley uses two or more belts, replace the belts as a complete set. NOTE: To prevent damage, do not roll a belt over the pulley or pry it on with a tool. Turn the adjusting screw to increase the belt tension. NOTE:
Belt tension can increase when the fan hub mount- ing capscrews are tightened. Do not adjust the belt tension to full value with the adjusting screw. Tighten the two capscrews until the fan hub is in correct alignment with the fan hub bracket. NOTE: Do not tighten the capscrews to full torque value. Measure the belt tension.