Cummins — ENGINE - REMOVAL FROM THE REBUILD STAND

Engine - Removal From the Rebuild Stand Engine Assembly (00-02) N14 Page 0-138 Refer to the Belt Tension Chart shown to select the cor- rect gauge and tension values for the belt width. Belt Tension Specifications Belt Tension New Belt SAE Gauge Installation Used Belt Belt Size Part No. Tension Tension Limits In.

Click-type Burroughs N lbf N min-max lbf .380 3822524 N/A 620 140 270-490 60-110 .440 3822524 N/A 620 140 270-490 60-110 1/2 3822524 ST-1138 620 140 270-490 60-110 11/16 3822524 ST-1138 620 140 270-490 60-110 3/4 3822524 ST-1138 620 140 270-490 60-110 7/8 3822524 ST-1138 620 140 270-490 60-110 4 Rib 3822524 ST-1138 620 140 270-490 60-110 5 Rib 3822524 ST-1138 670 150 270-530 60-120 6 Rib 3822525 ST-1293 710 160 290-580 65-130 8 Rib 3822525 ST-1293 890 200 360-710 80-160 10 Rib 3822525 3823138 1110 250 440-890 100-200 12 Rib 3822525 3823138 1330 300 530-1070 120-240 A belt is considered used if it has been in operation for at least 10 minutes. Tighten the two capscrews. Torque Value:

108 [80 ft-lb] Measure the belt tension again using service tool, ST- 1138. Adjust if necessary. When satisfactory belt tension is obtained, loosen the adjusting screw 1/2-turn to prevent breakage. Engine - Removal From the Rebuild Stand Use a lifting fixture, Part No. ST-125, and a hoist with a minimum lifting capacity of 4.5 M ton [5.0 tons] to lift the engine. Attach the lifting fixture to the hoist and the lifting bracket as shown.