Dipstick Tube and Housing - Installation Engine Assembly (00-02) N14 Page 0-140 Install and tighten the capscrews. Torque Value: 16 [140 in-lb] Dipstick Tube and Housing - Installa- tion Install the dipstick tube housing and a new gasket. Install the four capscrews, and tighten. Torque Value: 47 [35 ft-lb] NOTE: Check the dipstick calibration after the engine is installed in the vehicle chassis. Refer to N14 Troubleshoot- ing and Repair Manual, Bulletin No. 3810456. Water Header Covers - Installation Install new water header cover gaskets and the covers. Tighten the capscrews. Torque Value:
12 [110 in-lb] Coolant Inlet Transfer Connection - Installation Install the coolant inlet transfer connection and a new gasket on the water pump. Tighten the capscrews. Torque Value: 47 [35 ft-lb]