Cylinder Block Cylinder Block - Disassembly (01-01) N14 Page 1-9 Cylinder Block - Disassembly (01-01) Cam Bore Rear Cup Plug - Removal To remove the cup plug from the camshaft bore, use a center punch to mark the cup plug for drilling. Drill a 3.18 mm [1/8-inch] hole in the cup plug. Use an expansion plug removal tool, Part No. 3823159, to remove the cup plug. NOTE: Discard all used cup plugs. Straight Thread Plug and Pipe Plug - Removal Remove the straight thread plugs and pipe plugs from all oil passages in the cylinder block. Remove the straight thread plug from the piston cooling passage in the front of the cylinder block.
Remove the pipe plug from the main oil passage in the front of the cylinder block.