Cummins — DOWEL PIN - REMOVAL

Cylinder Block - Disassembly (01-01) Cylinder Block N14 Page 1-10 Remove the straight thread plug and pipe plug from the piston cooling oil passage on the exhaust side of the cylinder block. Remove pipe plugs from the coolant passage on the exhaust side of the cylinder block. Remove the straight thread plug from the piston cooling passage at the rear of the cylinder block. Remove the pipe plug from the main oil passage at the rear of the cylinder block. Remove the six pipe plugs and one straight thread plug from the main oil passage on the intake side of the cyl- inder block. Remove the straight threaded plug from the main oil transfer passage on the intake side of the cylinder block.

Dowel Pin - Removal Use a dowel pin extractor, Part No. ST-1134, or its equiv- alent. Remove the six cylinder head groove pins, two front cover dowel pins, one water pump dowel pin, six cam follower housing dowel pins, and two flywheel hous- ing dowel pins. Put the split collet (1) over the groove pin. Slide the extractor collar (2) over the split collet. Use the slide hammer (3) to push the extractor collar over the split collet tightly. Use the slide hammer to remove the groove pin.