Cummins — CYLINDER BLOCK - CLEANING

Cylinder Block Cylinder Block - Cleaning and Inspection (01-02) N14 Page 1-11 Camshaft Bushings - Removal Use camshaft bushing driver set, Part No. 3376637, and driver, Part No. 3375861, to remove bushings No. 1 through No. 7. Remove the No. 1 bushing first and then the remaining six (6) bushings in order from front to rear. To remove bushings No. 1 through No. 7, insert the tool assembly through the camshaft bore until the driver is against the bushing. Hit the slide hammer against the shaft assembly until the bushing is driven from the bore. To remove the No.

7 bushing during in-chassis camshaft bushing removal, insert the tool assembly through the bore until the pins of the puller assembly are engaged behind the bushing. Cylinder Block - Cleaning and Inspec- tion (01-02) Cylinder Block - Cleaning Caution: Do not damage the machined gasket surfaces or the camshaft bushings if the bushings have not been removed. Use a gasket scraper, wire brush, or a fibrous abrasive pad such as Scotch-Brite T No. 7447, Part No. 3823258, or its equivalent to clean heavy deposits off the cylinder block.