Cummins — CYLINDER BLOCK - CLEANING

Cylinder Block - Cleaning and Inspection (01-02) Cylinder Block N14 Page 1-14 Warning: Use a face shield, rubber gloves, an apron, and boots and obey the warning label on the cleaning solution used to prevent personal injury. Caution: Use a cleaning solution that will not damage the camshaft bushings if the bushings have not been removed. Remove the block from the engine stand. Put the block in a cleaning tank. Follow the instructions of the manufacturer of the clean- ing tank and the manufacturer of the cleaning solution. NOTE: Cummins Engine Company, Inc., does not recom- mend any specific cleaning solution.

The best results can be obtained by using a cleaning solution that can be heated to 80° C to 95° C [180 ° F to 200° F]. Use a cleaning tank that will mix and filter the cleaning solution to get the best results. Warning: Use a face shield, rubber gloves, an apron, and boots and obey the warning label on the cleaning solution used to prevent personal injury. Remove the block from the cleaning tank. Clean all the oil passages using a steam cleaner. Caution: Make sure all the water is removed from the capscrew holes and the oil passages to prevent rust formation in the cylinder block. Use compressed air to dry the block. Warning:

Naptha and methyl ethyl ketone (MEK) are flammable materials and must be used with care. Do not use starting fluid as a cleaning agent. It can cause per- sonal injury if ignited. Clean the cylinder block counterbores with a suitable hydrocarbon solvent such as naptha, methyl ethyl ketone (MEK), or trichlorethane 1, 1, 1 (methyl chloroform).