Cylinder Block Cylinder Block - Cleaning and Inspection (01-02) N14 Page 1-15 NOTE: If the cylinder block is not going to be used imme- diately, apply a coating of preservative oil to prevent rust. Cover the block to prevent dirt from sticking to the oil. Camshaft Bore - Cleaning Use a fine emery cloth to remove burrs, and clean the bushing bores. Camshaft Bore - Inspection Measure the cylinder block camshaft bore inside diam- eter. Camshaft Bore I.D. mm in 68.237 MIN 2.6865 68.262 MAX 2.6875 If the bore inside diameter is not within specifications, the bore must be repaired. Refer to the Alternate Repair Manual, Bulletin No. 3379035. Main Bearing Bore Alignment - Measurement NOTE:
Service caps do not have the bore machined to a final specification. If the cap is replaced, the main bearing bore must be machined. Use the correct parts of the main bearing boring tool, Part No. ST-1177. Refer to the Alterna- tive Repair Manual, Bulletin No. 3379035.