Cummins — MAIN BEARING BORE ALIGNMENT - MEASUREMENT

Cylinder Block - Cleaning and Inspection (01-02) Cylinder Block N14 Page 1-16 Use two centering rings, Part No. ST-1177-39 [4.750 inches diameter]. Put the rings in the No. 2 and the No. 6 main bearing locations. Use clean 15W-40 oil to lubricate the main bearing cap- screw threads and the flat washers. Drain the excess oil from the capscrews before installing them. Caution: The main bearing caps are marked for position (1) on the camshaft side and the cylinder block identi- fication (2) on the exhaust side. The cylinder block iden- tification number (3) is stamped on the pan rail on the camshaft side of the block.

Install the caps in the correct position with the position number to the camshaft side and its part number toward the rear of the engine. Install the main bearing caps as follows: 1. Align the capscrew holes in the cap with the holes in the cylinder block. 2. Install the capscrews and the washers through the cap and into the cylinder block. 3. Use your hand to tighten the capscrews two to three threads.