Cylinder Block Cylinder Block - Cleaning and Inspection (01-02) N14 Page 1-17 4. Hit the cap with a rubber mallet to push it into the correct position. NOTE: The main bearing caps must not have any side clearance with the block. Cylinder Block to Main Bearing Cap Press Fit mm in 0.03 MIN 0.001 0.15 MAX 0.006 Put the checking ring into the cylinder block main bearing saddle. Put the main bearing cap over the checking ring. Tighten the main bearing cap capscrews to the following torque values in the sequence shown: 1. Tighten to 120 [90 ft-lb]. 2. Tighten to 230 [170 ft-lb]. 3. Tighten to 345 [255 ft-lb]. 4. Loosen completely. 5. Repeat steps No. 1 through No. 3.
Use clean 15W-40 oil to lubricate the bores of the two centering rings, Part No. ST-1177-39, and the checking bar, Part No. ST-1177-16.