Cylinder Block - Cleaning and Inspection (01-02) Cylinder Block N14 Page 1-18 Insert the bar through the centering rings while slowly rotating the bar. The bar must turn easily. If the bar does not turn easily, check to make sure the main bearing caps are installed correctly. If they appear to be okay, move one of the centering rings to another bearing location. Slide one end of the bar out of a centering ring. Slide the checking ring, Part No. ST-1177-13, onto the bar. Insert the bar into the centering ring. Apply lubrication to the outside diameter of the checking ring. Use your hands to install the checking ring into the main bearing bore.
If the ring will not slide through the bore, check the bore for burrs. If the ring will still not slide through the bore, the bore is undersize and must be repaired. Refer to the Alternative Repair Manual, Bulletin No. 3379035, for repair procedures.