Cummins — MAIN BEARING BORE ALIGNMENT - MEASUREMENT

Cylinder Block Cylinder Block - Cleaning and Inspection (01-02) N14 Page 1-19 Use a 0.08 mm [0.003-inch] feeler gauge that is not more than 13 mm [0.5-inch] wide. Center the checking ring in the bore. Try to put the feeler gauge between the checking ring and the bore. Rotate the gauge in the bore at both sides of the checking ring. The bore alignment of the main bearing is okay if: the gauge does not enter at any point. the gauge will enter but will not slide through or around the bore and the alignment bar will rotate with the gauge inserted. The bore alignment of the main bearing is not okay if: the gauge enters and slides around the bore.

This means that the bore is oversize and must be re- paired. the gauge will enter on one side only but can slide around the bore. This means that the bore is ta- pered and must be repaired. If the tools to check the main bearing bore alignment are not available, use a dial bore indicator to measure the main bearing bore inside diameters. NOTE: This procedure does not check main bearing bore alignment but will identify bore diameters that do not meet specifications. NOTE: Support the rear portion of the block on a flat surface to obtain the most accurate measurement of the inside diameter.