Cylinder Block - Cleaning and Inspection (01-02) Cylinder Block N14 Page 1-20 Measure the inside diameter in the three positions shown. The inside diameter must be completely round within 0.0190 mm [0.00075-inch]. Main Bearing Bore I.D. (Capscrews Torqued to Specification) mm in 120.599 MIN 4.7480 120.637 MAX 4.7495 Cylinder Block - Inspection Caution: All measurements of the cylinder block must be made when the block is positioned on a flat surface. If the block is mounted on the engine stand, the mea- surements can be wrong because of distortion. Inspect the gasket surfaces. Visually inspect for burrs or damage. Use an Arkansas hone or a crocus cloth to remove the burrs.
Check the top surface of the block for wear. If fretting damage, scratches, cracks, or corrosion deeper than 0.08 mm [0.003-inch] are present in an area where a head gasket seal ring or a grommet makes contact, the surface must be repaired. There must not be any defect which extends more than 2.41 mm [0.095-inch] from the edge of the coolant passage. Fretting damage in any other area is acceptable if it does not change the protrusion measurement of the counter- bore or the cylinder liner. Refer to the Alternative Repair Manual, Bulletin No. 3379035, for machining instructions.
Use a 610 mm [24 inches] caliper to measure the height of the cylinder block from the main bearing bore outside diameter to the cylinder head deck surface. Cylinder Block Height mm in 421.87 MIN 16.609 422.45 MAX 16.632 If the height of the block is less than 422.12 mm [16.619 inches], a 0.25 mm [0.010-inch] oversize head gasket must be used.