Cummins — CYLINDER HEAD CAPSCREW HOLES - INSPECTION

Cylinder Block Cylinder Block - Cleaning and Inspection (01-02) N14 Page 1-21 The height of the block must not vary more than 0.05 mm [0.002-inch] from end to end of the block. If the block height is not within specifications, the top surface of the block must be machined or the block must be replaced. NOTE: If the top surface of the block is machined, the ledge depth of the cylinder liner counterbore must be machined. Refer to the NH/NT Counterbore Troubleshooting and Repair Manual, Bulletin No. 3810450, or the N14 Trou- bleshooting and Repair Manual, Bulletin No. 3810456, for detailed instructions.

To inspect the cylinder liner counterbore, refer to the NH/NT Counterbore Troubleshooting and Repair Man- ual, Bulletin No. 3810450, or the N14 Troubleshooting and Repair Manual, Bulletin No. 3810456, for complete instructions. Coolant Passage - Inspection Check the water holes. If erosion or pitting is more than 0.08 mm [0.003-inch] deep or extends more than 2.41 mm [0.095-inch] from the edge of the hole, the water hole must be repaired. Refer to Cylinder Block Machining - Coolant Passage Repair later in this section for details. Cylinder Head Capscrew Holes - Inspection Inspect the capscrew bosses for cracks or porosity that extend into the coolant cavities or that have damaged threads.

Thread repair inserts can be used to fix most cases of thread damage and minor cracks. Refer to Cylinder Head Capscrew Hole Repair in Section 1-03.