Cylinder Block - Machining (01-03) Cylinder Block N14 Page 1-22 Closed end thread repair inserts can be used in conjunc- tion with upper counterbore sleeves (0.020-inch oversize on the outside diameter or smaller), and coolant passage repair inserts. Cylinder blocks with vertical cracks that extend down over the counterbore ledge that can not be machined out using a 0.750-inch long sleeve can not be repaired. In this case, the cylinder block must be replaced. Mark all cylinder head capscrew holes that are to be repaired. Refer to Cylinder Block Machining - Cylinder Head Capscrew Hole Repair in Section 1-03.
Cylinder Block - Machining (01-03) Cylinder Block - Deck Resurfacing Refer to the Alternative Repair Manual, Bulletin No. 3379035.