Cylinder Block Counterbore - Inspection and Machining (1-04) Cylinder Block N14 Page 1-30 Make sure the inside portion of the repair insert is clean. Remove any file shavings or debris. Before tightening the cylinder head capscrews, allow the sealant to cure for 3 hours. Cylinder Block Counterbore - Inspec- tion and Machining (1-04) Due to the complex nature of troubleshooting procedures required for diagnosis and repair of counterbores, this information has been excluded from this manual. Com- plete counterbore repair guidelines can be found in the NH/NT Counterbore Troubleshooting and Repair Man- ual, Bulletin No. 3810450, and the N14 Troubleshooting and Repair Manual, Bulletin No.
3810456. Cylinder Block - Assembly (01-05) Camshaft Bushings - Installation Caution: Incorrect installation will block oil flow to the rocker levers and the cam followers resulting in severe damage to the engine. Refer to the numbers stamped on the bushings to determine the correct cylinder block cam bore locations in which the bushings are to be installed.