Cummins — CAMSHAFT BUSHINGS - INSTALLATION

Cylinder Block Cylinder Block - Assembly (01-05) N14 Page 1-31 Install the camshaft bushings in the following order: No. 7, No. 6, No. 5, No. 4, No. 3, No. 2, and No. 1. Bushing (No. 7) - Installation An alignment pointer, Part No. 3823635, is used to align the cam bearing oil holes with the oil holes in the block. To use, mount the bearing on the driver. Place the align- ment pointer against the machined side of the block at the cam follower holes with the end of the rod at the top of the bearing. Rotate the cam bearing until the seam of the bearing is at the end of the rod. Press the cam bearing in as described. Install the bushing marked No.

7 on the driver with the location notch to the rear of the engine and at the 6:00 o’clock position. Push the bushing into the bore until the oil holes in the bushing are aligned with the drillings in the bore. Use a 2.39 mm [0.094-inch] diameter rod or a 3/32-inch hexagon wrench to check the position and the location of the oil hole in the bushing and the cylinder block. The rod must pass through the oil holes in the bushing and into the oil supply drillings in the cylinder block.