Cummins — CAMSHAFT BUSHINGS - INSTALLATION

Cylinder Block - Assembly (01-05) Cylinder Block N14 Page 1-32 Bushings (No. 6 through No. 2) - Installation An alignment pointer, Part No. 3823635, is used to align the cam bearing oil holes with the oil holes in the block. To use, mount the bearing on the driver. Place the align- ment pointer against the machined side of the block at the cam follower holes with the end of the rod at the top of the bearing. Rotate the cam bearing until the seam of the bearing is at the end of the rod. Press the cam bearing in as described. Use bushing driver (1), Part No. 3375861, to install bush- ings No. 1, No. 2, No. 4, and No. 6. Use bushing driver (2), Part No. 3376412, to install bush- ings No.

3 and No. 5. Install the tool assembly through the camshaft bore until the driver is in the cavity between the bores where the bushing is to be installed. Install the bushing guide into the camshaft bore next to the bore where the bushing is to be installed. An alignment pointer, Part No. 3823635, is used to align the cam bearing oil holes with the oil holes in the block. To use, mount the bearing on the driver. Place the align- ment pointer against the machined side of the block at the cam follower holes with the end of the rod at the top of the bearing. Rotate the cam bearing until the seam of the bearing is at the end of the rod. Press the cam bearing in as described.