Cummins — CAMSHAFT BUSHINGS - INSTALLATION

Cylinder Block Cylinder Block - Assembly (01-05) N14 Page 1-33 Use a 2.39 mm [0.094-inch] diameter rod or a 3/32-inch hexagon wrench to check the position and the location of the oil hole in the bushing and the cylinder block. The rod must pass through the oil holes in the bushing and into the oil supply drillings in the cylinder block. Bushing (No. 1) - Installation NOTE: Camshaft bushing guide, Part No. ST-1228-6, is not used to install the No. 1 bushing. An alignment pointer, Part No. 3823635, is used to align the cam bearing oil holes with the oil holes in the block. To use, mount the bearing on the driver.

Place the align- ment pointer against the machined side of the block at the cam follower holes with the end of the rod at the top of the bearing. Rotate the cam bearing until the seam of the bearing is at the end of the rod. Press the cam bearing in as described. Use a 2.39 mm [0.094-inch] diameter rod or a 3/32-inch hexagon wrench to check the position and the location of the oil holes in the bushing and the cylinder block. The rod must pass through the oil holes in the bushing and into the oil supply drillings in the cylinder block. Measure the inside diameter of the installed camshaft bushings. Camshaft Bushing I.D. Installed mm in 63.457 MIN 2.4983 63.558 MAX 2.5023 NOTE:

If any of the bushings is not within specification, the bushing must be replaced.