Cummins — STRAIGHT THREAD PLUG AND PIPE PLUG - INSTALLATION

Cylinder Block - Assembly (01-05) Cylinder Block N14 Page 1-34 Dowel Pin - Installation NOTE: Do not install the dowel pins in the block until the inspection and any necessary repair procedures are com- pleted. Caution: Do not use a hammer. Damage to the dowel pin will result. Use a plastic mallet. Install the six cylinder head groove pins, two front cover dowel pins, one water pump dowel pin, six cam follower housing dowel pins, and two fly- wheel housing dowel pins. Straight Thread Plug and Pipe Plug - Installation Caution: Do not install straight thread plugs or pipe plugs in the block until cleaning, inspection, and nec- essary repair procedures are completed.

This will pre- vent dirt from being trapped in the engine. Use pipe sealant, Part No. 3375066, to lubricate the pipe plug threads. Install new o-rings on the straight thread plugs. The o-ring used by Cummins Engine Company, Inc., is the only one recommended by Cummins Engine Company. Lubricate the o-ring with clean 15W-40 oil. Install a 3/4 - 16 straight thread plug in the piston cooling oil passage. Tighten the straight thread plug. Torque Value: 75 [55 ft-lb] Install a 3/8-inch pipe plug in the main oil passage. Tighten the pipe plug. Torque Value: 27 [20 ft-lb]