Cummins — STRAIGHT THREAD PLUG AND PIPE PLUG - INSTALLATION

Cylinder Block Cylinder Block - Assembly (01-05) N14 Page 1-35 Install a 3/8-inch pipe plug in the piston cooling oil cross- over passage at the front of the cylinder block. Tighten the pipe plug. Torque Value: 27 [20 ft-lb] Install a 3/4 - 16 straight thread plug in the piston cooling oil passage at the rear of the cylinder block. Tighten the straight thread plug. Torque Value: 75 [55 ft-lb] Install a 3/4 - 16 straight thread plug in the piston cooling oil passage. Tighten the straight thread plug. Torque Value: 75 [55 ft-lb] Install a 3/8-inch pipe plug in the main oil passage. Tighten the pipe plug. Torque Value: 27 [20 ft-lb] NOTE:

These pipe plugs must be flush or below flush with the rear face of the cylinder block. Install the copper washer and the 7/8 - 18 straight threaded plug in the main oil crossover passage in the front of the cylinder block. Tighten the straight thread plug. Torque Value: 88 [65 ft-lb] Install six pipe plugs and one straight thread plug from the main oil passage on the intake side of the cylinder block. Install the straight threaded plug from the main oil trans- fer passage on the intake side of the cylinder block. (1) Torque Value: 55 [40 ft-lb] (2) Torque Value: 7 [5 ft-lb] (3) Torque Value: 25 [15 ft-lb] (4 to 7) Torque Value: 15 [10 ft-lb]