Cylinder Block Cylinder Liners - Cleaning and Inspection (01-06) N14 Page 1-37 Caution: Do not use a hone, deglazing, or prebrushing to clean the cylinder liners. Abrasives can damage the finish and the pattern and can contaminate the liner. Warning: Wear eye protection. Make sure the wire brush is rated for the RPM being used if the brush is motor driven. Use a high quality steel wire brush to clean the liner flange seating area. Use a fine, fibrous abrasive pad such as Scotch-Brite T 7448, Part No. 3823258, or its equivalent to remove the remaining carbon. Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield.
Hot steam can cause serious personal injury. Use a non-metallic bristle brush, detergent soap, and warm water to clean the inside diameter. Use a steam cleaner or a solvent tank to clean the liners. Dry with compressed air. Use clean 15W-40 oil to lubricate the inside diameter of the liners. Allow the oil to soak in the liner for 5 to 10 minutes. Continue to lubricate the inside of the liners and wipe clean until the paper towel shows no gray or black res- idue. NOTE: Use lint-free paper towels to wipe the oil from the inside of the liners.