Cylinder Liners - Cleaning and Inspection (01-06) Cylinder Block N14 Page 1-40 Replace the liner if: 1. a heavy polish is present over 20 percent of the piston ring travel area. 2. thirty percent (30%) of the piston ring travel area has both moderate and heavy polish, and one-half (15 percent) is heavy polish. Refer to Parts Reuse Guidelines, Bulletin No. 3810303, for further information. Use a dial bore gauge to measure the liner inside diam- eter in four places 90 degrees apart at the top and the bottom of the piston travel area. Cylinder Liner I.D. mm in 139.696 MIN 5.4995 139.827 MAX 5.5050 Replace the liner if measured dimensions exceed limits given above in the table.
Measure the liner flange outside diameter. Liner O.D. (Upper Flange Area) mm in Standard 166.72 MIN 6.564 166.77 MAX 6.566 Oversize 167.23 MIN 6.584 167.28 MAX 6.586 Measure the lower press fit area. Liner O.D. (Lower Press Fit Area) mm in Standard 159.91 MIN 6.296 159.96 MAX 6.298 Oversize 160.93 MIN 6.336 160.98 MAX 6.338