Cummins — INSPECTION

Cylinder Block Cylinder Liners - Cleaning and Inspection (01-06) N14 Page 1-39 Inspect for cracks under the flange. NOTE: Cracks can also be detected by using either mag- netic inspection or the dye method. Replace the liner if cracks are found in the flange area. Visually inspect the exterior of the liners. The presence of any coating can indicate an inadequate concentration level of supplemental coolant additives (SCA). The proper concentration level of SCA will protect against the for- mation of scale or oil coatings.

SCA’s form a very hard film on the coolant side of the liner which resists damage from the implosion of air bubbles.The microscopic pro- tective coating of ferrous oxide is invisible and will not be seen by the naked eye. Inspect the inside diameters for vertical scratches deep enough to be felt with a fingernail. NOTE: If a fingernail catches in the scratch, the liner must be replaced. Visually inspect the inside diameter for scuffing or scor- ing. Replace the liner(s) if excessive scuffing or scoring is present. Refer to Parts Reuse Guidelines, Bulletin No. 3810303, for further information. Visually inspect the inside diameter for liner bore polish- ing.

A moderate polish produces a bright mirror finish in the worn area with traces of the original hone marks or an indication of an etch pattern. A heavy polish produces a bright mirror finish in the worn area with no traces of hone marks or an etch pattern.