Pistons - Cleaning and Inspection (01-07) Cylinder Block N14 Page 1-42 Inspection Visually inspect the piston bowl, the pin bore, and the skirt for cracks or damage. Use crack detection kit, Part No. 3375432, or equivalent to check for cracks on the top of the piston and in the piston pin bore. NOTE: Do not use pistons with dome cracks larger than one-half (1/2) the rim width or with cracks which extend over the rim toward the ni-resist insert. Do not use pistons with dome cracks in the rim above the pin bore axis. Do not use pistons with cracks in the piston pin bore. Do not use pistons with scuff marks, visually unacceptable scratches or cracks in the skirt.
If pistons are unacceptable for reuse, do not use the mating piston pins. Cummins recommends replacing pistons and pins in sets. Visually inspect the piston ring lands and ring grooves for wear. A worn groove will have a detectable step at the back of the groove and a rolled edge at the surface of the piston or the ring groove outside diameter. Pistons ex- hibiting this wear are not acceptable for reuse. Refer to the Parts Reuse Guidelines, Bulletin No. 3810303. Use piston ring groove wear gauges, Part No. 3823870, 3823869, and a 5-6 inch micrometer, to inspect the top and second grooves (compression rings). NOTE:
The piston must be replaced if measured dimen- sions are less than those in the table below. Measure each ring groove (diameter over pins) when the piston temperature is at 21°C [70°F] in two places 90 degrees apart as shown. Ring Groove Wear Limits (Diameter Over Pins) mm in Top Ring Groove: 140.2 MIN 5.515 2nd Ring Groove: 140.1 MIN 5.514