Cylinder Block Connecting Rod Assemblies - Cleaning and Inspection (01-08) N14 Page 1-43 Measure the piston pin bore when the piston temperature is at 21°C [70°F] in two places 90 degrees apart. Piston Pin Bore mm in 63.504 MIN 2.500 63.530 MAX 2.5012 NOTE: Add 0.013 mm [0.0005-inch] to the bore inside di- ameter per 5°C [10°F] temperature rise up to 32°C [90°F]. Visually inspect the piston pin for scratches, grooves, or other damage. Do not reuse if visually unacceptable. Measure the piston pin outside diameter at both ends as shown in two places 90 degrees apart. Piston Pin Outside Diameter mm in 63.4848 MIN 2.4994 63.4997 MAX 2.4999 NOTE:
Discard the piston pin if it is more than 0.03 mm [0.001-inch] out of round. If piston pin measurements exceed those in the table, do not reuse. If the piston pin is unac- ceptable for reuse, do not use the matching piston. Cum- mins recommends replacing pistons and pins in sets. Connecting Rod Assemblies - Cleaning and Inspection (01-08) Cleaning NOTE: The alpha characters or numbers on the connecting rod cap must be the same as the alpha characters or num- bers on the rod. Do not assemble a new cap to a used rod or a used cap to a new rod. Remove the capscrews and the caps from the rods. Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield.
Hot steam can cause serious personal injury. Use solvent or steam to clean the rods. Use a soft bristle brush to clean the oil drilling. Dry with compressed air.