Cummins — FIXTURE - CALIBRATION

Cylinder Block Connecting Rods - Bend and Twist Inspection (01-09) N14 Page 1-47 Connecting Rod Ring Dowels - Removal Caution: Do not damage the surface or the ring dowel hole during removal of the dowel. Use pliers or locking pliers to remove the damaged ring dowels. Use a blunt punch, if necessary, to bend the ring in for removal. Connecting Rod Ring Dowels - Installation Caution: Do not use a hammer or damage to the dowel will result. Use a plastic mallet to install the ring dowel. Connecting Rods - Bend and Twist Inspection (01-09) Fixture Calibration Use a connecting rod checking fixture, Part No. ST-561, and a connecting rod mandrel set, Part No.

3823785, to inspect the bend and the twist of the rods. Calibrate the checking fixture with a new rod that has been measured for correct center to center length, 304.75 mm to 304.80 mm [11.998 inches to 12.000 inches]. NOTE: Assemble the connecting rod cap to the rod as described in Connecting Rods - Inspection. Install the piston pin mandrel from the connecting rod mandrel set, Part No. 3823785, into the piston pin bore. NOTE: Use a mandrel, Part No. 3823787, if the piston pin bushing has been removed or the mandrel, Part No. 3823788, if the bushing is still in place. Install the mandrel, Part No. 3823786, into the crankshaft bore and expand the mandrel. NOTE:

Make sure the pin on the mandrel is pointed down and locked in position in the center of the connecting rod.