Connecting Rod Assemblies - Cleaning and Inspection (01-08) Cylinder Block N14 Page 1-46 Measure the connecting rod bearing bore inside diame- ter. Connecting Rod Crankshaft Bore I.D. mm in 93.731 MIN 3.6902 93.769 MAX 3.6917 If any of the measurements are not within the specifica- tions, the rod must be repaired or replaced. Measure the piston pin bushing inside diameter. Piston Pin Bushing I.D. mm in 63.525 MIN 2.5010 63.581 MAX 2.5032 If the bushing does not meet the specifications, the rod must be replaced. Caution: The connecting rod must be assembled with the capscrews tightened to specifications before stamp- ing identification numbers or alpha characters on the rod.
If a new connecting rod is installed, always check the rod and cap assemblies identification to make sure it does not match any of the other rod and cap assemblies in that engine. If it does, the rod and cap must be stamped so they can be differentiated from the other rod and cap assemblies. Refer to the Alternate Repair Manual, Bulletin No. 3379035, for procedures to magnetically check for cracks in the connecting rods and capscrews.