Cylinder Block Connecting Rod Bearings - Cleaning and Inspection (01-10) N14 Page 1-49 Measure the rod length and bend (alignment). Connecting Rod Length mm in 304.75 MIN 11.998 304.80 MAX 12.000 Connecting Rod Alignment mm in Bushing Removed 0.25 MAX 0.010 Bushing Installed 0.10 MAX 0.004 Twist - Inspection Using a feeler gauge, check the clearance between the mandrel and the dial indicator holding plate as shown. Connecting Rod Twist mm in Bushing Removed 0.50 MAX 0.020 Bushing Installed 0.25 MAX 0.010 Connecting Rod Bearings - Cleaning and Inspection (01-10) NOTE: The bearings must be marked for location as they are removed for future identification.
Each bearing must be installed in its original location if the bearing is used again. Cleaning Caution: Do not use a scraper or a wire brush. The bear- ings can be damaged. Use solvent and a soft bristle brush. Dry with compressed air. Inspection Visually inspect the bearings for damage. Replace any bearings with the following damage: Pitting Flaking Corrosion Lock tang damage Scratches (deep enough to be felt with a fingernail) Refer to the Parts Reuse Guidelines, Bulletin No. 3810303, for further information.