Connecting Rod Bearings - Cleaning and Inspection (01-10) Cylinder Block N14 Page 1-50 NOTE: If large areas of copper lining are visible in the bear- ings before the engine has accumulated 241,000 kilometers [150,000 miles] or 3,750 hours, inspect the engine for con- tamination from fine dirt particles; and correct the problem to prevent further engine damage. Normal bearing wear produces a smooth finish which will wear into the copper lining. Exposed copper does not always indicate worn bearings. Visually inspect the bearing seating surface for nicks or burrs. If burrs can not be removed with a fine crocus cloth, the bearings must be replaced. NOTE:
For more detailed information of bearing damage, refer to Analysis and Prevention of Bearing Failures, Bulletin No. 3810387. Measure the rod bearing shell thickness at the wear lo- cation with an outside micrometer that has a ball tip. Connecting Rod Bearing Thickness (Standard) mm in 2.362 MIN 0.0930 2.405 MAX 0.0947 Discard a bearing shell if its thickness is below the min- imum specification. NOTE: Oversize bearing shells are available for crankshafts which are 0.25 [0.010-inch], 0.51 mm [0.020-inch], 0.76 mm [0.030-inch], or 1.02 mm [0.040-inch] undersize.
Bearing shells are identified by steel stamped characters on the back of the bearings to indicate either standard or the amount of oversize.