Cummins — CLEANING

Crankshaft - Cleaning and Inspection (01-14) Cylinder Block N14 Page 1-54 Inspection Caution: Always wear protective gloves when handling heated parts. Personal injury can result. Apply a spray of spot check developer, type SKD-NF T , or its equivalent, to the damper. Put the damper (seam side down) into an oven heated to 93°C [200°F] for 2 hours. Remove the damper from the oven, and visually inspect for oil leaks. Crankshaft - Cleaning and Inspection (01-14) Cleaning NOTE: New crankshafts are coated with a heavy preserva- tive. Use solvent to thoroughly remove the coating. Brush or flush the packing debris from the oil drillings before install- ing crankshaft in the engine.

Use a light preservative to prevent rust during engine rebuild. Use a fine crocus cloth or a 400 grit emery cloth to remove discoloration or light scratches from the machined surfaces. Use a hone stone. Polish the outside diameter at the front and the rear oil seal locations, the flywheel mounting location, and the vibration damper location. Remove all the small scratches and the grooves.