Cylinder Block Crankshaft - Cleaning and Inspection (01-14) N14 Page 1-55 Use a bristle brush, Part No. ST-876, and solvent to clean all the oil drillings. Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam can cause serious personal injury. Steam clean the crankshaft and dry it with compressed air. NOTE: Make sure to blow out the threaded holes on each end of the crankshaft and the oil drillings. Inspection Visually inspect the machined surfaces for scratches or nicks. Use a fine crocus cloth to remove the nicks and scratches. NOTE:
If scratches or nicks can be felt with a fingernail after the crankshaft has been polished with a crocus cloth, the crankshaft must be replaced or reconditioned. Visually inspect the threaded capscrew holes for dam- age. Use one of the following methods to repair any threaded holes: 1. Use a tap to clean the burrs from the threads. 2. Use a thread repair insert. If necessary, refer to the Alternative Repair Manual, Bul- letin No. 3379035, for repair instructions.