Cummins — INSPECTION

Crankshaft - Cleaning and Inspection (01-14) Cylinder Block N14 Page 1-56 NOTE: A maximum of 50 percent of the threaded holes per crankshaft end can be repaired. Visually inspect the crankshaft gear for cracks and broken or chipped teeth. Where the front and the rear crankshaft seals contact the crankshaft, the maximum allowable wear is 0.13 mm [0.005 in]. Crankshaft Oil Seal Wear Groove mm in 0.13 MAX 0.005 Measure the crankshaft gear fit area outside diameter (if the gear has been removed). Crankshaft Gear Fit Area O.D. mm in 95.501 MIN 3.7599 95.522 MAX 3.7607